Woodturner's Resource
Woodturner's Resource  
  Featured Artist    Websites   Support Wr
Tutorials, Projects & Tips   Event Calendar   Tool and Book Store
  Home Page Forum HelpSearch Map TPT Resources LoginRegister
 
Pages: 1 2 3 
Send Topic Print
Coring systems (Read 1,062 times)
 
Ed Weber
WR Global Moderator
WR Patron
*****
Offline



Posts: 4,858

Wilton, California, USA
Wilton
California
USA

Gender: male

JET 1642
Grizzly G0584
Re: Coring systems
Reply #30 - May 26th, 2017 at 8:34am
 
robo_hippy wrote on May 26th, 2017 at 12:04am:
If you have ever tried to remove the nub left when the core pops out, your tip can be at center height, but as soon as it touches the nub, it can drop up to an inch because of the flex. I think this is one of the reasons that we can get so much chatter some times, especially in harder woods. When the tip starts cutting, it goes down below the center line, which is not good for scrapers.


I agree, and add that sometimes it's necessary to adjust the speed as you get closer to the center. With the majority of the tool beyond the rest, vibration can be factor. Small speed adjustments can help to minimize this.
Back to top
  
 
IP Logged
 
Pages: 1 2 3 
Send Topic Print